Second transfer high-voltage power supply
Before proceeding, remove the following components:
●
Rear cover. See
Rear cover on page 93.
●
Right-rear cover. See
Right-rear cover on page 95.
Remove the second transfer high-voltage power supply
CAUTION: ESD-sensitive part.
1. Remove the DC controller and the DC controller support by releasing the cables from the guides,
and then removing six screws (callout 1).
Figure 2-98 Remove the second transfer high-voltage power supply (1 of 2)
1
ENWW Removal and replacement procedures 155
To Next Page
Loading...