Clean the product
During the printing process, paper, toner, and dust particles can accumulate inside the product. Over
time, this buildup can cause print-quality problems such as toner specks or smearing. This product has
a cleaning mode that can correct and prevent these problems.
Clean the product using HP ToolboxFX
1. Open HP ToolboxFX. See
Open HP ToolboxFX on page 200.
2. Click the System Settings folder, and then click the Service page.
3. In the area for Cleaning Mode, click the Start button to begin the cleaning process.
The product processes a single page, and then returns to the Ready state when the cleaning
process is complete.
Clean the product using the control panel
1. Press the OK button to open the menus.
2. Press the arrow buttons to highlight the Service menu, and then press the OK button.
3. Press the arrow buttons to highlight the Cleaning Mode menu, and then press the OK button.
4. Follow the control-panel instructions to complete the process.
Clean the product using the embedded Web server
1. Open the embedded Web server.
2. Click the System tab.
3. Click the Service menu.
4. Click the Start button.
5. Follow the product control-panel instructions to complete the process.
246 Chapter 3 Solve problems ENWW
To Next Page
Loading...