EasyManua.ls Logo

HP COMPAQ DC5750 - HP Insight Diagnostics

HP COMPAQ DC5750
51 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Data transfer rate
Standard rates of 1, 2, 5.5, 11, 6, 9, 12, 18, 24, 48, 54 and Super AG Mode108-
Mbps
Spreading
DSSS (Direct Sequence Spread Spectrum)
Security
64(40h) bit, 128(104h) bit, WPA, IEEE802.1X, AES-OCB, AES-CCM, Microsoft
PEAP,TKIP, WEP.
Antenna
External 5dBi antenna
Throughput
108 Mbps (only with Belkin 54G or
above router that supports 108 Mbps
speed)
200 ft (60.96 m) – Indoor
54 Mbps
200 ft (60.96 m) – Indoor
11 Mbps
200 ft (60.96 m) – Indoor
Certifications
Wi-Fi certified
Certifications for use by
country
North America: United States, Canada
2006 Agere PCI 56K
International SoftModem
Data Transmission
Technology speeds: 56,000 Kbps maximum downstream data, controllerless
NOTE:
56 Kbps technology refers to download speeds only and requires compatible modems at server
sites. Other conditions may limit modem speed. FCC limitations allow a maximum of 53 Kbps during
download transmissions.
Data Speeds
(Upload only)
33,600/31,200/28,800/26,400/21,600/19,200/16,800/14,400/12,000/
9,600/7,200/4,800/2,400/1,200/300
Data Standards
ITU-T V.90, ITU-T, ITU-T V.34, V.44, V.42, V.42bis21, V.32bis, Bell 212A, and
Bell 103
Fax Speeds
14,400/12,000/9,600/7,200/4,800/2,400/1,200/300 b/s
Fax Mode Capabilities
ITU-T T.31 class 1 FAX, V. 17, V.29, V.27ter, and V.21 Channel 2
Error Correction and Data
Compression
V.44, 42bis, V.42 and MNP2-5
Power Management
ACPI; PPMI 1.1 and wake support with PME and Vaux; meets PCI 2.3
requirements and PC 2001 requirements
Upgradeability
Driver upgradeable for future enhancements
Video
ITU-T V.80 video ready interface
Other
TIA/EIA 602 standard AT command set
Integrated DTE interface with speeds of up to 115.2 Kbps, parallel 16550a
UART-compatible interface
Optional ring wakeup signal
Operating Temperature
32° to 158° F (0° to 70° C)
Operating Humidity
20% to 90%, non-condensing
Power
Requires a 3.3-V auxiliary power rail on PCI bus
Uses only one PCI load (i.e., one grant/request pair), one shared IRQ, one
electrical load
Chipset
Agere Systems SV92PL – Integrated PCI interface with 5-V tolerant buffers
and CardBus support
QuickSpecs
HP Compaq dc5750 Business PC
Technical Specifications - Communications
DA - 12546 North America — Version 39 — October 29, 2008
Page 24

Other manuals for HP COMPAQ DC5750

Related product manuals