EasyManuals Logo
Home>HP>Desktop>Compaq dc7100 CMT

HP Compaq dc7100 CMT User Manual

HP Compaq dc7100 CMT
212 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #171 background imageLoading...
Page #171 background image
Technical Reference Guide 361834-001 A-3
Error Messages and Codes
512-Chassis Fan Not Detected Chassis fan is not connected.
514-CPU or Chassis Fan not
detected.
CPU fan is not connected or may have malfunctioned.
601-Diskette Controller Error Diskette drive removed since previous boot.
605-Diskette Drive Type Error Mismatch in drive type.
912-Computer Cover Removed
Since Last System Start Up
Cover (hood) removal has been detected by the Smart Cover Sensor.
914-Hood Lock Coil is not
Connected
Smart Cover Lock mechanism is missing or not connected.
916-Power Button Not Connected Power button harness has been detached or unseated from the system
board.
917-Expansion Riser Not Detected Expansion (backplane) board not seated properly.
919-Front Panel, MultiPort, and/or
MultiBay Risers not Detected
Riser card has been removed or has not been reinstalled properly in
the system.
1156-Serial Port A Cable Not
Detected
Cable from serial port header to I/O connector is missing or not
connected properly.
1157-Front Cables Not Detected Cable from front panel USB and audio connectors is missing or not
connected properly.
1720-SMART Hard Drive Detects
Imminent Failure
SMART circuitry on an IDE drive has detected possible equipment
failure.
1721-SMART SCSI Hard Drive
Detects Imminent Failure
SMART circuitry on a SCSI drive has detected possible equipment
failure.
1785-MultiBay incorrectly installed For MultiBay option or
non-USDT systems:
Multibay option ribbon cables not seated or improperly attached.
or
MultiBay device not properly seated.
or
MultiBay diskette present
For integrated MultiBay/ USDT systems:
MultiBay device not properly seated.
or
MultiBay riser not properly seated.
1794--Inaccessible device attached
to SATA 1
(for systems with 2 SATA ports)
A device is attached to SATA 1. Any device attached to this connector
will be inaccessible while “SATA Emulation” is set to “Combined IDE
Controller” in Computer Setup.
Table A-2. (Continued)
Power-On Self Test (POST) Messages
Error Message Probable Cause

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Compaq dc7100 CMT and is the answer not in the manual?

HP Compaq dc7100 CMT Specifications

General IconGeneral
BrandHP
ModelCompaq dc7100 CMT
CategoryDesktop
LanguageEnglish

Related product manuals