Hardware Reference Guide www.hp.com 2–21
Hardware Upgrades
10. Line up the tabs on the expansion card assembly with the slots on
the computer chassis and press the assembly firmly down into
place.
Installing the Expansion Card Assembly
11. Connect external cables to the installed card, if needed. Connect
internal cables to the system board, if needed. If the card requires
audio, connect the audio cable to the connector on the system
board labeled “Aux” (located under the power supply cage).
12. Replace the access panel.
13. Install the optional cable lock, if desired.
14. Replace the stand, if desired.
15. Reconnect all external devices, plug the power cord into the
power outlet, and turn the computer on.
16. Use Computer Setup to enable the Smart Cover Sensor, if
desired.
To Next Page
Loading...
