10 Computer Setup Utility Guide
Computer Setup (F10) Utility
Hardware Monitor
(Continued)
HVcc (+3.3VSB) Detects current HVcc voltage
Password Option Change Supervisor
Password
Allows you to set and change the
supervisor password
Password Status Shows password status
Password Check Allows you to set the password check
when the supervisor password is set up
• Setup: Password prompt appears
when BIOS is executed
• Always: Password verification is
checked every time the computer
boots (Default)
Load Default Settings None Loads the optimal default values for all of
the setup options
Save Settings and Exit None Saves changes and exits setup.
Exit Without Savings None Allows you to exit setup without saving
any changes
Computer Setup (Continued)
Heading Option Description
✎
Support for Computer Setup options may vary depending on your specific hardware
configuration.
To Previous Page
Loading...
