Service Reference Guide, dx2000 ST 371411-001 6–21
Removal and Replacement Procedures— Slim Tower (ST) Chassis
6.10 Power Switch Assembly
1. Prepare the computer for disassembly (Section 6.1, “Preparation for Disassembly”).
2. Disconnect the power switch/LED cable from the system board.
3. Carefully cut the cable tie that secures the power switch cable to the power supply cable
cable bundle.
Ä
CAUTION: Be careful when cutting the cable tie not to cut any cables.
4. Squeeze the switch holder retaining clips together at the front of the chassis 1 and push the
switch assembly out of the chassis 2.
To install the power switch assembly, reverse the removal procedure.
To Next Page
Loading...
