To Next Page

To Previous Page

Using the Auto-Adjustment Function

You can optimize the screen performance for the VGA (analog) input by using the OK/auto button on

the monitor and the auto-adjustment pattern software utility on the CD provided.

Do not use this procedure if the monitor is using a DVI or DisplayPort input. If the monitor is using a

VGA (analog) input, this procedure can correct the following image quality conditions:

●

Fuzzy or unclear focus

●

Ghosting, streaking or shadowing effects

● Faint vertical bars

●

Thin, horizontal scrolling lines

●

An off-center picture

To use the auto-adjustment feature:

1. Allow the monitor to warm up for 20 minutes before adjusting.

2. Press the OK/auto button on the monitor front panel.

●

You can also press the Menu button, then select Image Control > Auto-Adjustment from

the OSD Main Menu. Refer to

Adjusting the Monitor Settings on page 20 in this chapter.

●

If the result is not satisfactory, continue with the procedure.

3. Insert the CD in the disc drive. The CD menu is displayed.

4. Select Open Auto-Adjustment Software. The setup test pattern is displayed.

5. Press the OK/auto button on the monitor front panel to produce a stable, centered image.

6. Press the ESC key or any other key on the keyboard to exit the test pattern.

18 Chapter 4 Operating the Monitor ENWW

Other manuals for HP Compaq LA2006x

Questions and Answers:

Need help?

Do you have a question about the HP Compaq LA2006x and is the answer not in the manual?

General