To Next Page

To Previous Page

3 Setting Up the Monitor

To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other

attached devices, then follow the instructions below.

Unfolding the Monitor Pedestal Base

1. Lift the monitor from its box and place it face down on a flat surface.

2. Hold down the monitor base with one hand (1) then grasp the handle with the other hand and unfold

the display head 90 degrees (2).

CAUTION: Do not touch the surface of the LCD panel. Pressure on the panel may cause non-

uniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover to its

normal condition.

Figure 3-1 Unfolding the Monitor Pedestal Base

NOTE: When the monitor is unfolded for the first time, the display head is locked from adjusting to a

full-height position. To adjust the display head to full height, press down on the display head to unlock

it then pull up on the display head to raise it to the full-height position.

ENWW Unfolding the Monitor Pedestal Base 5

Other manuals for HP Compaq LA2405wg

Questions and Answers:

Need help?

Do you have a question about the HP Compaq LA2405wg and is the answer not in the manual?

General