Figure 3-14 Print on Both Sides Instructions screen
Flip Pages Up
The Flip Pages Up check box, enabled only when the Print on Both Sides (Manually) check box is
selected, is used to specify the duplex-binding option. By default, the Flip Pages Up check box is
cleared. The following table demonstrates the results of selecting this box, depending on the paper
orientation selected on the Finishing tab.
Table 3-2 Page orientation
Orientation (Finishing tab) Flip Pages Up selected Flip Pages Up not selected
Portrait Short-edge binding Long-edge binding
Landscape Long-edge binding Short-edge binding
When the Print on Both Sides check box is selected, the document preview image changes to show
a spiral binding along either the left edge or the top edge of the page. In addition, a folded-over corner
appears in the lower-right portion of the preview image, indicating that printing occurs on the back side.
An arrow on the folded-over corner points in the direction that the pages would be flipped if they were
bound together.
When print on Letter-size media in portrait orientation, selecting the Flip Pages Up check box results
in pages that read by flipping over like the pages of a calendar. Clearing the Flip Pages Up check box
results in pages that read by turning like the pages of a book.
Booklet Printing
The Booklet Printing drop-down menu, visible when the Print on Both Sides check box is selected,
offers choices that are based on the current paper size. The default setting for the Booklet Printing
ENWW Finishing tab features 85
HP Color LaserJet
CP1210 Series Print
Driver
To Next Page
Loading...