Hardware Reference Guide www.hp.com 2–15
Hardware Upgrades
1. Install the four guide screws (two on each side) that were
removed from the old drive into the new drive. The screws help
guide the drive into its proper position in the bay. Extra guide
screws are provided on the front of the chassis under the front
bezel.
✎
There are a total of eight extra guide screws on the front of the chassis
under the bezel. Four have 6-32 standard threads and four have M3
metric threads. Standard screws are used for hard drives and have a
silver finish. Metric screws are used for all other drives and have a
black finish. Make sure to install the appropriate guide screws into the
drive.
2. Slide the drive into the drive bay, making sure to align the guide
screws with the guide slots, until the drive snaps into place.
Sliding the Drives into the Drive Cage
To Next Page
Loading...
