HP DesignJet 130nr Parts Reference Guide

DesignJet 130n
r
HP Parts Reference Guide™
www.h
p
.com/
g
o/h
pp
arts
Electrical/Electronic
Cable
1
C7790-60204 Front panel cable - Connects the front panel to the main logic PC board
C7791-60213 Motor harness - Connects to the carriage motor
3
C7791-60214 Encoder harness
4
C7791-60231 Duplexer OOP sensor harness
Front Panel
5
C7791-60141 Front panel assembly
PC Board
6
C7791-60132 Main logic PC board module - PC board is housed inside this metal chassis
7
C7791-60219 Cleanout interconnect PCA
Power Supply
8
C7790-60091 Worldwide input power supply module - 100V - 240V, 68W 50/60Hz - Includes fan
Sensor
9
C7790-60119 Door sensor assembly - Senses when the access door is opened or closed
External Case Parts
Cover
10
C7791-60216 Rear trim kit - Attaches to the rear of the printer on either side of the back/center cover (two used)
11
C7791-60285 Back/center cover - Covers the back and center of the printer and is located under the access door
12
C7791-60286 Right cover assembly - Houses the ink supply station and service station
13
C7791-60300 Left cover assembly - Houses the control panel
Door
14
C7790-60457 Printhead door assembly - Provides access to the printheads - Includes ink cartridge door hinge
15
C7791-60127 Rear cleanout door assembly - Used to remove paper jams
16
C7791-60277 Access door - Covers the top of the printer and provides access to the printheads and carriage
17
C7791-60295 Ink cartridge door - Provides access to the ink cartridges - DesignJet 130nr ONLY
Other Internal Parts
Absorber
18
C7790-60144 ISS rear aborber foam - Absorbs excess ink during the cleaning process - Larger of two
19
C8109-67022 ISS bottom aborber foam - Absorbs excess ink during the cleaning process - Smaller of two
Belt
20
C7791-60233 Carriage belt - Used to move the carriage from side to side
Carriage Kit
21
C7791-60142 Carriage assembly - Includes trialing cable
C7791-60279 Carriage assembly - Includes trialing cable
Encoder
23
C7791-60205 Encoder strip - Clear strip with position markers
Filter
24
C7790-60146 Filter Assembly - Located inside the right cover assembly
C7790-60295 New Part for C7790-60146
Holder
25
C7790-60104 Encoder strip holder - Wire loop that connects to the carriage assembly that is used to hold the encoder strip
26
C7790-60124 Ink tube holder - Holds the ink tubes from the RIDS assembly
© 2004 Hewlett-Packard 1
www MK-Electronic de

HP DesignJet 130nr Specifications

General

Brand	HP
Model	DesignJet 130nr
Category	Printer
Language	English