4-26
Service Tests and Utilities
HP Designjet 4500 Printer Series Service Manual
55 The following message will appear on the Front Panel. Remove the media if
it is still loaded.
56 The Printer will now check the Media Drive and the Feed Roller 2:
57 The Input Media Driver Multiplexer will start and configure for Roll 2
Module. If there is a failure at this point, the Front Panel will display System
Error Code 01.0:10. For more information on troubleshooting this error
code, refer to Page 2-3.
58 The following message will appear on the Front Panel, load media into the
Roll 2 Module and press any key to continue the test.
a The Printer tests the Back Tension Arm 2 Encoder. If there is a failure at
this point, the Front Panel will display System Error Code 56.2:10.
For more information on troubleshooting this error code, refer to Page 2-
21.
b The printer moves the Back Tension Arm 2 to the maximum and minimum
position. If there is a failure at this point, the Front Panel will display
System Error Code 56.2:10. For more information on
troubleshooting this error code, refer to Page 2-21.
c If the media slips away from the drive roller a warning message is
displayed.
59 The front panel displays the results of the test, press any key to continue.
Starting Media Path.
60 If there is a failure at this point, the Front Panel will display System Error
Code 81:10. For more information on troubleshooting this error code, refer
to Page 2-27.
Configuring media path for Roll 2 Module.
To Next Page
Loading...
