HP Designjet 4500 Series - Page 334

8-34
Removal and Installation
HP Designjet 4500 Printer Series Service Manual
Vacuum Fan
Removal
Switch off the product and remove the power cable.
1. Remove the Right Cover
⇒ Page 8-8 .
2. Remove the Rear Door
⇒ Page 8-23.
3. Remove the Right Connector Cover ⇒ Page
8-25.
4. Remove the Service Station ⇒ Page 8-30.
5. Release the Pinchwheel Lever Sensor Cable
from the Vacuum Fan.
6. Disconnect both Vacuum Fan cables from
the Interconnect PCA.