HP Designjet 4500 Series - Page 51

2-21
System Error Codes
HP Designjet 4500 Printer Series Service Manual
Power cord. Reconnect the power cord and power On the Printer.
 Replace the Encoder Disc and Sensor ⇒ Page 8-120.
 If the System Error continues, replace the PrintMech PCA ⇒ Page 8-91 .
System Error:
56:10
Problem
Description:
Drive Roller Encoder sensor failed.
Corrective Action: Try the following:
 Replace the Encoder Disc and Sensor ⇒ Page 8-120.
System Error:
56.1:10
Problem
Description:
Roll 1 BT Arm encoder.
Corrective Action: Try the following:
 Replace the Encoder Disc and Sensor ⇒ Page 8-167 and Page 8-168.
System Error:
56.2:10
Problem
Description:
Roll 2 BT Arm encoder.
Corrective Action: Try the following:
 Replace the Encoder Disc and Sensor ⇒ Page 8-223.
System Error:
61:01
Problem
Description:
The file format is incorrect and the Printer cannot process the job.
Corrective Action: Try the following:
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 Check the graphic language setting of the Printer (Refer to the User’s
Guide).
 Resend the file to the Printer.
 Check that the Printer has the latest Firmware version. If not, update the
Firmware to the latest version.
System Error:
61:04.1
Problem
Description:
The Postscript fonts are missing. Upgrading the Firmware will re-install the
fonts.
Corrective Action: Perform a full firmware upgrade that includes package ’B’.