36 Front-Panel Error Messages
Paper too small to align The paper loaded is not big enough to contain the alignment pattern.
Unload the paper (select Unload roll or Unload sheet from the Ink menu) and then
load paper that is large enough—at least A4/Letter-size in landscape mode for
Standard alignment, or A3/B size in landscape mode for Special alignment.
Paper too small to print the
pattern
The paper loaded is not big enough to contain the paper axis calibration pattern.
Load a roll or sheet that is at least 65 cm (25 inches) long and 50 cm (20 inches)
wide.
Pattern not found
Reload it again, please
The printer is trying to perform a scan of the calibration pattern, but the pattern was
not found.
Reload the sheet that was printed by the Create pattern part of the calibration
routine.
Message Explanation and Action
To Next Page
Loading...
