front-panel error messages
Front-Panel Error Messages 35
Paper too big
Press ENTER to retry
Press CANCEL to abort
While loading paper into the printer (roll or sheet), the printer has found that it is either
too wide or too long (only for sheet) to be loaded properly.
Press the Enter key to load smaller paper, or the Cancel key to stop the load.
Paper too big to scan the
pattern after printing it
During the paper loading for the Calibration routine, the printer has detected that the
paper will not be loadable later when it will be needed for scanning. The minimum
size required for the print is 65 cm (25 inches) long and 50 cm (20 inches) wide.
Load a smaller sheet that satisfies this minimum requirement.
Paper too small
Press ENTER to retry
Press CANCEL to abort
While loading paper into the printer (roll or sheet), the printer has found that it is either
too narrow or too short (only for sheet) to be loaded properly.
Press the Enter key to load larger paper, or the Cancel key to stop the load process.
Paper too small for a
diagnostic print
The Troubleshooting utility has found that the single sheet loaded in the printer is too
small for a Diagnostic Print.
Load a roll of paper, or a sheet that is A3-size or larger.
Message Explanation and Action
To Next Page
Loading...
