how do I change the
graphics language setting?
hp designjet
5500 series
welcome
how do I ...
tell me about ...
the problem is ...
legal notices
glossary
index
Unless you are troubleshooting any of the problems listed under Comments
in the table below, you should not need to change the default setting.
To change the graphics language setting, choose the
icon, then Device
Setup > Lang, where the following options are available:
Language Comments
Automatic
Choose Automatic to let the printer determine
which type of file it is receiving. This setting
works for most software applications.
HP-GL/2
Choose this setting if you are not working with
PostScript files, and you have experienced image
position problems or timing problems.
PostScript
Choose PostScript if you are printing only
PostScript files and your PostScript jobs do not
include PJL language switching commands.
TIFF, JPEG, PDF, CALS G4
Choose these options only if you are sending a
file of the appropriate type directly to the printer
without going through a printer driver. This is
normally done only from WebAccess, in which
case the language setting is done by WebAccess
and you do not have to do it yourself.
© 2002 hewlett-packard company
file:///C|/Documents%20and%20Settings/---/Desktop/HP/html/p0215.htm [8/5/2002 4:49:28 PM]
To Next Page
Loading...