how do I align the
printheads?
hp designjet
5500 series
welcome
how do I ...
tell me about ...
the problem is ...
legal notices
glossary
index
The printer will normally perform an alignment automatically whenever any
printhead is replaced. However, you can turn off this automatic alignment by
choosing the
icon, then Internal RIP Settings > Align Calibration > Off.
You can also request a printhead alignment from the front panel at any time
by choosing the
icon, then Utilities > Calibrations > Printhead Alignment.
In this case the printer will align the printheads immediately; or, if an image
is being printed, as soon as the current print job is finished. The alignment
procedure requires a minimum paper size of A1/D-size (24 inches).
You can use this feature if the
image quality print indicates an alignment
error.
When the front panel displays Ready, you are ready to print.
Make sure the printer window and the right door are closed after you replace
the HP supplies. The printer will not print while these are open.
Watch the animation below.
© 2002 hewlett-packard company
file:///C|/Documents%20and%20Settings/---/Desktop/HP/html/p0092.htm [8/5/2002 3:29:54 PM]
To Next Page
Loading...