loading rolls onto the
spindle
hp designjet
5500 series
welcome
how do I ...
tell me about ...
the problem is ...
legal notices
glossary
index
This procedure shows you how to load rolls onto the spindle and into the
printer's spindle hubs.
Make sure the printer wheels are locked (the brake lever is pressed down) to
prevent the printer from moving.
If the roll is very wide, rest the spindle horizontally on a table and load the
roll on the table.
When adjusting the spindle guides, move them as close to the roll as you
can, without applying excessive force.
The printing material should hang down from the roll exactly as shown.
Watch the animation below.
© 2002 hewlett-packard company
file:///C|/Documents%20and%20Settings/---/Desktop/HP/html/p0035.htm [8/5/2002 2:38:12 PM]
To Next Page
Loading...