loading rolls into the
printer
hp designjet
5500 series
welcome
how do I ...
tell me about ...
the problem is ...
legal notices
glossary
index
This procedure shows you how to load a roll into the printer. It includes
references to the take-up reel. Front-panel messages that are applicable only
if you have a take-up reel installed are highlighted in green.
If your printer is the HP Designjet 42 inch/1.07 m, the take-up reel is an
optional accessory. See
ordering other accessories.
To start this procedure you need to have a roll loaded on the printer spindle.
See
loading rolls onto the spindle.
When adjusting the spindle guides, move them as close to the roll as you
can, without applying excessive force.
The animation shows the Media Length Tracking function turned On.
Watch the animation below.
© 2002 hewlett-packard company
file:///C|/Documents%20and%20Settings/---/Desktop/HP/html/p0037.htm [8/5/2002 2:38:12 PM]
To Next Page
Loading...