10. After waiting a few moments to allow both connectors to dry, replace the printhead into the printhead
carriage. See
Replace a printhead on page 30.
11. After completing the cleaning process, open the carriage interconnect wiper by pulling on the sponge
tab.
12. Remove the soiled sponge from the carriage interconnect wiper.
13. Dispose of the soiled sponge in a safe place to prevent the transfer of ink onto hands and clothing.
If the front panel continues to show the Reseat or Replace message, replace the printhead or call your
service representative.
Clean the exterior of the printer
Use a damp sponge or a soft cloth and a mild household cleaner such as non-abrasive liquid soap to clean the
outside of the printer and all other parts of the printer that you regularly touch as part of normal operation
(for example, ink cartridge drawer handles).
There may be some dampness from condensation under the fans of the curing module, which should be
wiped with a dry cloth.
WARNING! To avoid an electric shock, make sure that the printer is turned OFF and unplugged before you
clean it. Do not let water get inside the printer.
CAUTION: Do not use abrasive cleaners on the printer.
16 Chapter 4 Hardware maintenance ENWW
To Next Page
Loading...