4. Apply a few drops of the oil to the pads on either side of the carriage.
5. Apply a few drops of oil directly to the slider rod on either side of the carriage.
Press OK when this has been done.
6. Clean the substrate jam reflector using a lint-free cloth dampened with distilled water. If you find
dried ink that you cannot remove, try using a lint-free cloth dampened with 95% ethanol.
Press OK when this has been done.
7. If the front panel prompts you to oil the rollers, see
Lubricate the platen rollers on page 20. Press
OK when this has been done.
8. Close and lock the printer window.
Lubricate the platen rollers
If you notice that the platen rollers are squeaking, it is time to lubricate them. Locate the oil bottle in the
User Maintenance Kit that came with your printer.
1. Unlock and open the printer window.
20 Chapter 4 Hardware maintenance ENWW
Maintain hardware
To Next Page
Loading...
