5. Push down as indicated by the arrow.
CAUTION: You might feel some resistance when installing the new printhead, so you need to
press it down firmly but smoothly. You should hear a beep and see confirmation on the front-panel
display that the printhead has been inserted.
6. Insert all of the other printheads that need to be installed, and close the carriage cover.
7. Make sure that the end of the latch catches the wire loop on the near side of the carriage.
8. Lower the latch to rest on the carriage cover.
When all of the printheads have been inserted correctly and the printer has accepted them, the
printer beeps.
NOTE: If the printer does not beep when you insert the printhead and the Replace message
appears on the front-panel display, you might need to reinsert the printhead.
34 Chapter 4 Hardware maintenance ENWW
Maintain hardware
To Next Page
Loading...
