3. Carefully insert the leading edge of the substrate above the black-ribbed roller, making sure the
substrate remains taut during the process. Avoid rewinding the substrate manually, unless the
printer asks you to do so. The front panel displays the following.
4. Continue to feed the substrate until it reaches the printing platen. Open the window to help pull
the substrate through.
WARNING! Do not touch the printer's drying enclosure. Even after you have opened the
window latch, which disconnects the power to the drying and curing modules, the internal
surfaces could be hot.
TIP: If the substrate you are using tends to curl, keep feeding the substrate until the edge is out of
the printer. You are also recommended to use the take-up reel, or to disable the cutter from the
front panel if not using the take-up reel.
5. Pull down the substrate-adjustment lever as far as it will go.
ENWW
Load a roll into the printer (manually)
31
Handle the substrate
To Next Page
Loading...
