4. Use the winding button on the take-up reel motor to wind the excess substrate around the take-up
reel spindle.
5. Press the OK button on the front panel. The printer asks you to cut the substrate manually.
6. Use the winding button on the take-up reel motor to wind the remainder of the substrate around the
take-up reel spindle.
7. Press the OK button on the front panel.
The amount of printed substrate that is on the take-up reel spindle appears on the front panel.
8. Unlock the take-up reel spindle by pushing the spindle lever to its uppermost position.
48 Chapter 4 Handle the substrate ENWW
Handle the substrate
To Next Page
Loading...
