The following picture shows an edge holder correctly placed.
NOTE: When you use the edge holders, your prints should have a minimum margin of 10 mm.
The loading accessory
The loading accessory is designed to help in loading banner/textile/mesh substrates. It is
recommended when loading such substrates, but not obligatory.
NOTE: The edge holders can be used whether or not you decide not to use the loading accessory.
1. Select Load with accessory from the Substrate Load menu on the front panel.
NOTE: If you select Load with accessory, a message is displayed asking whether you want
to use the edge holders.
50 Chapter 4 Handle the substrate ENWW
Handle the substrate
To Next Page
Loading...
