Enable/disable the length tracking feature
1.
The length tracking feature can be disabled or enabled from the front panel. Select the
icon,
then Substrate handling options > Substrate length tracking.
2. Select On or Off.
Store the substrate
The following are tips for storing substrate:
●
Always keep unused rolls wrapped in the plastic wrap to prevent discoloration and dust
accumulation. Rewrap partially used rolls if they are not being used.
●
Do not stack rolls.
●
Allow all substrates to adapt to room conditions out of the packaging for 24 hours before printing.
●
Handle film and glossy substrates by the edges or wear cotton gloves. Skin oils can be transferred
to the substrate, leaving fingerprint marks.
●
Keep the substrate tightly wound on the roll throughout the loading and unloading procedures. If
the roll starts to unwind, it can become difficult to handle.
58 Chapter 4 Handle the substrate ENWW
Handle the substrate
To Next Page
Loading...
