●
Vertical bands.
●
Horizontal bands.
●
Coalescence, grain (can be caused by an excess of light ink).
Try reducing the amount of ink in your RIP software, then reprint the chart and check again.
You may have chosen a media preset that uses more ink than your substrate allows. Consult your
RIP documentation to make sure you’re applying the right media preset, and to find out how to
lower the total ink limits of the media preset. For a quick solution, you could change to a different
media preset that uses less ink: for example, paper-aqueous presets use less ink than self-adhesive
presets.
68 Chapter 5 Substrate settings ENWW
Substrate settings
To Next Page
Loading...
