HP DesignJet Series - Power Supply Unit Removal

7-22
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Power Supply Unit
Removal
Switch off the product and remove the power cable.
1. Remove the Center Cover
⇒ Page 7-7 .
2. Remove the Right End Cover
⇒ Page 7-9 .
3. Remove the Electronics Module ⇒ Page 7-18 .
Following two steps only
applicable to Designjet 10ps, 20ps,
30, 30n, 50ps
4. Disconnect the Motor Harness Cable.
5. Remove 1 T-10 screw (Typ
e A) that
secures the Grounding Strip.
Disconnect