HP DesignJet Series - Service Station Removal Procedure

7-24
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Service Station
Removal
Switch off the product and remove the power cable.
1. Remove the Center Cover
⇒ Page 7-7 .
2. Remove the Right End Cover
⇒ Page 7-9 .
3. Remove the Electronics Module ⇒ Page 7-18.
4. Remove the Power Supply Unit ⇒ Page 7-22.
Following step is not applicable to
Designjet 10ps, 20ps, 30, 30n,
50ps
5. Remove 2 screws that secure the
Reinforcement Bracket. Remove the
Reinforcement Bracket from the Printer.
6. Disconnect the Service Station Cable.