7-38
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
10. Release the Trailing Cable from the
Chassis.
Following step only applicable to
90, 90r, 130, 130nr
11. Remove 2 T-10 screws that secure the
Turnaround Stopper. Remove the
Turnaround Stopper from the Printer.
12.
Release the Belt from the Carriage Motor by
pushing in the Turnaround Assembly (right
hand side of the printer) and at the same
time releasing the Belt from the Motor on the
left hand side of the printer.
1
2
To Next Page
Loading...