HP DesignJet Series - Page 179

7-47
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Ramp Motor Assembly
(Not applicable to 10ps, 20ps, 30, 30n, 50ps)
Removal
Switch off the product and remove the power cable.
1. Remove the Center Cover
⇒ Page 7-7.
2. Remove the Left End Cover ⇒ Page 7-11 .
3. Remove the Starwheel Assembly
⇒ Page 7-
43.
4. Remove the Print Platen Assembly ⇒ Page
7-44
.
5. Remove 2 T-10 screws that secure the Front
Lef
t Bracket.
6. Remove the Front Left Bracket from the
Pri
nter.