7-49
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Output Mechanism Assembly (Applicability: 10ps, 20ps,
30, 30n, 50ps)
Removal
Switch off the product and remove the power cable.
1. Remove the Front Cover
⇒
Page 7-6.
2. Remove the Center Cover
⇒
Page 7-7.
3. Remove the Right End Cover
⇒
Page 7-9
.
4. Remove the Left End Cover
⇒
Page 7-11.
5.
Remove the Output Separator
⇒
Page 7-46.
6. Remove the Starwheel Assembly
⇒
Page 7-
43.
7. Release the Belt from the Output
Mechanism Assembly.
8. Release the locking mechanism from the
lef
t hand side of the Printer.
1
2
3
To Next Page
Loading...