7-54
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Feed Roller Assembly (Applicability: 10ps, 20, 30, 30n,
50ps)
Removal
Switch off the product and remove the power cable.
1. Remove the Front Cover
⇒
Page 7-6
.
2. Remove the Center Cover
⇒
Page 7-7
3. Remove the Right End Cover
⇒
Page 7-9
.
4. Remove the Left End Cover
⇒
Page 7-11
.
5.
Remove the Electronics Module
⇒
Page 7-
18.
6. Remove the Starwheel Assembly
⇒
Page 7-
43.
7. Remove the Output Separator
⇒
Page 7-
46.
8. Remove the Output Mechanism Assembly
⇒
Page 7-49.
9. Remove the Paper-Axis Motor Drive
Assembly
⇒
Page 7-56.
10. Release the locking mechanism from the
left hand side of the Printer.
11. Release the locking mechanism from the
ri
ght hand side of the Printer.
1
2
1
2
To Next Page
Loading...