HP DesignJet Series - Page 188

7-56
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Feed Roller Assembly
(Not applicable to Designjets 10ps, 20ps, 30, 30n, 50ps)
Removal
Switch off the product and remove the power cable.
1. Remove the Center Cover
⇒ Page 7-7
2. Remove the Right End Cover ⇒ Page 7-9 .
3. Remove the Left End Cover
⇒ Page 7-11 .
4. Remove the Electronics Module ⇒ Page 7-
18.
5. Remove the Power Supply Unit ⇒ Page 7-
22.
6. Remove the Service Station ⇒ Page 7-24.
7. Remove the Starwheel Assembly ⇒ Page 7-
43.
8. Remove the Print Platen Assembly ⇒ Page
7-44.
9. Remove the Spittoon (if installed) ⇒ Page 7-
51.
10. Remove the Pivot Assembly ⇒ Page 7-52.
11. Disconnect the Paper-Axis and Encoder
cables.