HP DesignJet Series - Page 198

7-66
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
22. Remove the Hanger Assembly from the
Printer.
If there are any cables still
attached between the Hanger
Assembly and the Printer then
disconnect them before removing
the Hanger Assembly.
23. Release the locking mechanism that
secures the Pick Assembly on the right
hand side of the printer (looking from the
rear).
24. Release the locking mechanism that
sec
ures the Pick Assembly on the left hand
side of the printer (looking from the rear)
1
2
3
1
2
1
2