HP DesignJet Series - Page 200

7-68
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Pinch Assembly (Applicability: 10ps, 20ps, 30, 30n, 50ps)
Removal
Switch off the product and remove the power cable.
1. Remove the Center Cover
⇒ Page 7-7.
2. Remove the Cleanout Assembly ⇒ Page 7-
31.
3. Remove the Pick Assembly
⇒ Page 7-62.
4. Release the Out-of-Paper Sensor from the
Pinch Assembly by pinching the tabs on
either side.
5. Release ALL the Pinch Springs from the
Pi
nch Assembly.
1
1
2