HP DesignJet Series - Paper-Axis Motor Drive Assembly Removal

7-75
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Paper-Axis Motor Drive Assembly (Applicable only to
10ps, 20ps, 30, 30n, 50ps)
Removal
Switch off the product and remove the power cable.
1. Remove the Center Cover
⇒ Page 7-7.
2. Remove the Left End Cover ⇒ Page 7-11.
3. Disconnect the Paper-Axis and Encoder
cables.
4. Remove 1 T-10 screw (Typ
e A) that
secures the Paper-Axis Motor Mount.
5. Release the locking mechanism that
se
cures the Paper-Axis Motor Mount.
1
2