4-2
Utilities
HP Designjet Ultra Low End Printer Service Manual
Utilities
The following Utilities are available through the printer:
1 Enable/disable bu
zzer ⇒ Page 3
This utility allows you to switch Off or On the internal buzzer.
2 T
ransport Position ⇒ Pa
ge 3.
This utility allows you to put the printer in a stable condition before
transpor
ting it to another location.
3 Printhead Recovery ⇒ Pa
ge 4
This utility helps maintain proper operation of all nozzles in the printheads.
Th
is is only recommended if you are experiencing problems with print
quality such as banding.
4 Netw
ork Card Reset ⇒ Pa
ge 6.
Use this utility to reset the HP Jetdirect card configuration to the factory
def
aults. This should only be used if the HP Jetdirect card is not responding
and no other recovery method works.
5 S
et to Factory Defaults ⇒ Pa
ge 6. RESTRICTED ACCESS
Use this utility to return to the default settings that were set in the factory.
6 H
ard EEPROM reset ⇒ Pa
ge 7. RESTRICTED ACCESS
This utility allows you to reset the EEPROM inside the Printer.
7 S
et Flag to Prime Tubes ⇒ Pa
ge 8. RESTRICTED ACCESS
The purpose of this utility is to prime the Ink Supply Tubes after they have
been r
eplaced (or if a situation arises where you need to force the priming).
How to Access Restricted Access Utilities
Some of the Service Utilities are restricted to hp qualified personnel only. To
access these restricted service utilities, while the printer is switched OFF,
press both the resume and power buttons together until the Tool icon
appears on the front panel.
Tool Icon
press both the resume and
power buttons together
To Next Page
Loading...