HP DesignJet Series - Network Card Reset; Set to Factory Defaults

4-6
Utilities
HP Designjet Ultra Low End Printer Service Manual
Network Card Reset
Use this utility to reset the HP Jetdirect card configuration to the factory
defaults. This should only be used if the HP Jetdirect card is not responding
and no other recovery method works.
Any user configuration information, for example the IP address, will be lost.
In this c
a
se the computer will not be able to communicate with the printer
using the network.
The HP Jetdirect card will need to be reconfigured, using WebJetAdmin for
ex
ample, after this reset.
Reset the Network Card as follows:
1 Hold the pow
er button down and press the cancel button three times and
the resume button once.
Set to Factory Defaults
Use this utility to return to the default settings that were set in the factory.
Return to Factory Defaults as follows:
1 Hold the pow
er button down and press the cancel button three times and
the resume button twice.
Hold Power Button
Press Resume button once
Press Cancel
button three times
Hold Power Button
Press Resume button twice
Press Cancel
button three times