System Error Codes
2-15 HP Designjet T Series — Service Manual
1 Switch the Power OFF from the back of the Printer and disconnect the Power
cord. Check the Primer Tubes. Reconnect the power cord and power On the
Printer.
2 Make sure that the Service Station path is clear. Remove any visible
obstacles (e.g. screws, plastic parts, etc...) restricting the movement of the
Service Station.
3 Perform the Service Station diagnostic test to troubleshoot the problem
further. See
8. Service Station on page 3-41.
4 If the System Error continues, replace the Service Station. See Service Station
(T1100/T1100ps/T610) on page 6-61 or Service Station (T1120/T1120ps/
T620) on page 6-65.
5 If the System Error continues, replace the PrintMech PCA. See PrintMech
PCA (T1100, T1100ps, T610 ONLY) on page 6-73.
System Error: 21.1:YZ
Problem
Description:
Fail moving the Primer Motor of the Service Station.
Corrective Action: Try the following:
1 Remove the Right Cover and make sure the cables from the Printmech PCA to
the Service Station are connected and are not damaged (T1100/T1100ps/
T610 ONLY).
2 Perform the Service Station diagnostic test to troubleshoot the problem
further. See
8. Service Station on page 3-41.
3 If the System Error continues, replace the Service Station. See Service Station
(T1100/T1100ps/T610) on page 6-61 or Service Station (T1120/T1120ps/
T620) on page 6-65.
4 If the System Error continues, replace the PrintMech PCA. See PrintMech
PCA (T1100, T1100ps, T610 ONLY) on page 6-73.
Warning: 2x.n:10
Problem
Description:
Ink supply error found during IDS diagnostic test. The n represents the ink
supply that is failing. The ink supply furthest to the left is always 0, and then
they count up from left to right.
Corrective Action: Try the following:
Replace the Left Ink Supply Station. See Left Ink Supply Station on page 6-
187 .
Left Ink Supplies
01 2 3 4 5
To Next Page
Loading...