1. Remove the spindle from the printer one end at a time.
WARNING! Do not insert your fingers into the spindle supports during the removal
process.
2. The spindle has a stop at each end to keep the roll in position. The blue stop can be removed to
mount a new roll; it slides along the spindle to hold rolls of different widths. Remove the blue paper
stop from the end of the spindle.
3. If your roll has a three-inch cardboard core, ensure that the core adaptors supplied with the printer
have been installed.
ENWW Load a roll onto the 24-inch spindle 37
Paper handling
To Next Page
Loading...