HP Designjet T1100 - Page 102

HP Designjet T Series — Service Manual 2-42
Appendix A: How to troubleshoot SE 79:04
 Conditions where the problem occurs and conditions prior to the first
occurrence of the problem
 The results of the previous 8 steps
 The System Error detailed information (this can be obtained by pressing
CANCEL + Down)
 The printer logs. In order to obtain the printer logs, check the
corresponding appendix. See
Appendix C: Obtaining printer logs on
page 2-46.
Front panel displays 79:04 during printer operation – not
w
hile sending jobs
1 R
eboot the printer.
2 U
pgrade the printer’s firmware. Even if the currently installed firmware
version is the latest one, re-install it.
3 R
eset the printer to factory defaults
4 In or
der to narrow the scope of the issue, try the following:
a Disable the
queue
b Disable a
ny unused network protocols
c Disa
ble SNMP and WebServices (if they are available in the printer)
d Disable “
Sleep mode” from the Service Utilities menu
e Delet
e any Paper Presets that you may have uploaded or created using
the printer Spectrophotometer
5 R
estart the printer in Diagnostics Boot Mode and perform the “Electronics
test”. If an electronic component is identified as faulty, replace it.
6 R
estart the printer in Diagnostics Boot Mode and Reset the EEROM. If the
issue is solved by this, this is a data related 79:04 system error and you
should follow the guidelines for this type error. See
Data related SE79:04 on
page 2-35.
7 F
ormat the Hard Disk drive. To do so, you will need to start the printer
normally, enter the Service Utilities menu and then the Secure Disk Erase
option. Set the Erase method to “Fast Erase” and then perform the disk erase
process. This will take 45-75 minutes and will erase all user information from
the disk, resolving any issue caused by corrupt data. After the erase process,
a firmware update will be required. If this solves the issue, this is a data
related 79:04 system error and you should follow the guidelines for this type
of error. See
Data related SE79:04 on page 2-35.
8 T
ry to identify the combination of settings or actions that led to the system
error and try to reach the same result with a different combination. Escalate
the issue to fix the original problem.
9 If
none of the previous steps could solve the issue, escalate it with the
following information:
 Unit information: S/N, P/N, accessories
 Conditions where the problem occurs and conditions prior to the first
occurrence of the problem
 The result of the previous 8 steps