Service Tests and Utilities
3-4 HP Designjet T Series — Service Manual
This option allows you to view the Firmware Version, Part Number, and
Serial Number of the Printer.
11 EER
OM Reset. See 11. EEROM Reset on page 3-50
The purpose of this test is to reset the EEROM values.
12 Set
Unit Configuration. See 12. Set Unit Configuration on page 3-51
Not implemented.
13 Er
ror 71:19 Recovery. See 13. Error 71:19 Recovery on page 3-51
The purpose of this utility is to set the Serial Number and Part Number in
case both the Formatter and the PrintMech PCA are replaced at the same
time or select the correct Serial Number and Part Number if only one of the
components has been replaced.
14 Othe
rs. See 14. Others on page 3-55
Not implemented.
To Next Page
Loading...