HP Designjet T1100

HP Designjet T Series — Service Manual 4-5
Service Calibrations
position to the Black Printhead. This calibration is integrated into the Scan
Axis diagnostic test. See
1. Scan Axis on page 3-6.
Perform the Scan Axis Calibration as follows:
Make sure you load one of the following media into the
Printer before performing this calibration:
 HP Bond Paper.
 HP Glossy Media.
 HP Coated Paper.
 HP Productivity Photo Gloss.
 HP Heavyweight Coated Paper.
 HP Super Heavyweight Coated Paper.
 HP Bright White Inkjet Paper.
1 In the Service Calibrations submenu, scroll to Scan Axis Calibration and
press Enter.
2 To calibrate the Scan Axis, run the Scan Axis diagnostic test.. See 1. Scan
Axis on page 3-6.
Service Station Calibration
The purpose of this Service Calibration is to calibrate the Service Station in
relation to the Carriage Assembly. This calibration is integrated into the
Scan Axis diagnostic test. See
8. Service Station on page 3-42.
1 In the Service Calibrations submenu, scroll to Ser
vice Station and press
Enter.