HP Designjet T1100 - Page 333

HP Designjet T Series — Service Manual 6-97
Removal and Installation - Encoder Strip, spring and attachment nut (T1100/T1100ps/
T610)
6. Loosen the T-10 uncapping screw
sufficiently so you can manually move the
Carriage Assembly in step
7.
If you are uncapping a 44 inch
printer, you will need to use either
a very long or very short
screwdriver to loosen the
uncapping screw. In this way, you
can loosen the screw and pass the
rewinder motor.
7. Push the Carriage Assembly into the print
path.
8. Unclip the Encoder Strip tensioner from the
right hand end.
44 inch T1100 printer shown (with Rewinder)
2
1