HP Designjet T Series — Service Manual 6-121
Removal and Installation - Carriage Assembly (T1100/T1100ps/T610)
25.Loosen the T-10 uncapping screw
sufficiently so you can manually move the
Carriage Assembly in step
26.
If you are uncapping a 44 inch
printer, you will need to use either
a very long or very short
screwdriver to loosen the
uncapping screw. In this way, you
can loosen the screw and pass the
rewinder motor.
26.Push the Carriage Assembly into the print
path.
27. Unclip the small cover of the Carriage
PCA.
44 inch T1100 printer shown (with Rewinder)
To Next Page
Loading...