HP Designjet T Series — Service Manual 6-186
Removal and Installation - Left Ink Supply Station
11. Carefully lift the Cartridge Tubes Connector
out of the Left Ink Supply Station.
12. Carefully lift the Left Ink Supply Station
enough so that you can rotate it
counterclockwise to release the front
attachment from the printer.
13. Carefully lift the Left Ink Supply Station
completely out of the printer.
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
see Service Calibration Guide to Removal and Installation
on page 6-5.
1
2
To Next Page
Loading...