HP Designjet T Series — Service Manual 6-238
Removal and Installation - Left Starwheel Lifter
8. Tilt the Left Starwheel Lifter sufficiently to
disengage the left attachment lug.
9. Remove the Left Starwheel Lifter from the
printer.
Do NOT remove the spring from
the Left Starwheel Lifter, because it
is difficult to reattach.
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
see Service Calibration Guide to Removal and Installation
on page 6-5.
To Next Page
Loading...